Yaesu VR-5000

[dg4dsl]

I use a Yaesu VR-5000. The device does not respond to the control program. I have tried several settings without success. What can I do to?
Thank you!

[iz2bkt]

I use a Yaesu VR-5000. The device does not respond to the control program. I have tried several settings without success. What can I do to?
Thank you!

Hi,
Can you make sure your VR-5000 is set up at 38400 bauds, 8N1,
and NO hardware handshake (no CTS/RTS) ?

[dg4dsl]

Does not work anyway. I have tried all possible settings.

[iz2bkt]

Sorry, this program uses HamLib to communicate with the rtx, try to see the HamLib forum http://sourceforge.net/projects/hamlib/f...orum/25919

[dg4dsl]

Thanks for the reply. I also use fldigi that works well with hamlib. There, the control works without problems.

[iz2bkt]

Please, how you've set fldigi? Thanks.

[dg4dsl]

I use standard settings of hamlib, set of fldigi.

Use Hamlib
Retries 0
Write Delay 70
Retry Intervall 1000
Post write delay 210
Baud rate 4800
Stopbits 2
Sideband Rig mode

[iz2bkt]

From the Alpha 20 version I've added new settings in the "COM setting", if you want to do some testing. Thanks.

[dg4dsl]

Thank you! It does not work with the new version. Do I need to change the "CI-V address" something? The entry is 0.

[iz2bkt]

The CI-V address is only used with the RTX Icom.