CatBkt and BKTRemoteServer

[DD8JM]

Hello,
I have a problem:
I use IC7100bkt, there goes even so far everything.
Now I have my IC7400 connected and configuriert with CatBkt.
Here I have the IC746 specified because there is no ic7400 in the list.

I use a Samsung S4 when I go online and BKTRemoteServer connecte, I get an error message on the computer:

Command not supported in any way by this RTX.

I've tried various transceiver, IC756, IC756Pro, IC7000 there is always the same error message.

If I Acknowledge the error at the computer goes everything, even the voice goes well.

The meeting with the voice over is a good thing, I've tried many programs but this program makes it first. Otherwise, I've been using Skype for voice transmission.

What I have to say, the program leuft not very reliable, there are a few crashes, can I receive voice but not send.

Error come on even when the reproduced connection and new connection again.
There is no connection to conditions, I have to finish everything and reconnect again.

Otherwise everything is very good.

My english is very bad, I hope you have understood it as far as what my problem is. :oops:

Best regards from Germany

Joerg de DD8JM

http://www.saure.org
http://www.dd8jm.de

[iz2bkt]

Hi Joerg,
instead of CatBkt, try to use the program IC706_BKT, in configuration choose RTX=OTHER and CIV Address that of your RTX.

[DD8JM]

Hi Mauro,
thanks for your help, the IC706 I had not tried, I'll try.

Thank you.

nice time

Joerg de DD8JM

[DD8JM]

Hi Mauro
I IC706_BKT charged me for my IC7400 and there are no errors.

But what is unfortunately no longer is the PTT since I can no longer select control over CAT here. :?

Unfortunately, PTT is no longer.

Is there still a solution for this.

many greetings

Joerg de DD8JM

[iz2bkt]

Ok, now try IC7000BKT, in configuration change only the CI-V address.