Frequency from JTDX to IC-7000

[un7_Andy]

I don't have frequency control from the JTDX program on the IC7000Bkt.
I don’t know whether such a function is built into the program or not.
I would like to control the transceiver via a chain...
JTDX -> IC7000Bkt->IC-7000.
If there is such a possibility, please advise.
It’s somewhat inconvenient now to set the frequency from IC7000Bkt.
-----
When setting the frequency from JTDX, the transceiver frequency is not controlled, and there is also no transition through frequency ranges.

[iz2bkt]

Hi,
to use JTDX with IC7000BKT, please refer to this guide: https://www.maniaradio.it/forum/showthread.php?tid=403

[un7_Andy]

Hello again Mauro. I have the same connection now. With IC7000BKT and BktNetInterface there is control for the transceiver and JTDX monitors the frequency.
There is no response - I change the range to JTDX, the transceiver frequency does not change.
That's why I asked this question.
The program is great, it's just that this feature would improve the management.
Thanks Mauro. GL & 73!

[iz2bkt]

You need to download and install the plugin BktNetInterface, then configure both BktNetInterface and JTDX as explained in the post, and everything works perfectly: the radio sets the frequency on JTDX, and JTDX sets the frequency on the radio.

It's important to follow all the points from 1 to 9 explained in the post https://www.maniaradio.it/forum/showthread.php?tid=403.

[iz2bkt]

In this video, starting from minute 6:47, it shows how to configure BktNetInterface and JTDX. The video uses IC7300BKT, but the operation is the same for IC7000BKT.

FT8 - BBLOGGER - JTDX - IC-7300 - YouTube

[un7_Andy]

All stages have been completed on this topic.
I will look for the reason.
Thanks for answers.