Need TCP data info

[Dany]

OK Mauro, thank you for your valuable response. It is very useful for me!

The only thing I can't find is the file "BKTExtension.dll", which I need in order to begin my preliminary tests.

Is this file included in my CatBkt installation folder, or is it available separately?

73,
Daniel
LU4EG

Hi Daniel,

the LAN protocol used by CatBkt is not a proprietary one — it follows the DXLab Commander TCP/IP protocol exactly.
You can find the full specification here:

https://www.dxlabsuite.com/commander/Com...ssages.pdf

CatBkt implements the same message set defined by DXLab, so the commands for reading and setting frequency, mode, split, and other CAT functions are those described in the Commander protocol documentation.

If you need full radio control and your application is 32‑bit, you can alternatively use the CATBkt extension DLL, which is already included with CatBkt.
A small Visual Basic example project is available here:

https://www.maniaradio.it/dll/TestDLL_CAT_VB.zip

Using the DLL gives you direct access to all CAT functions supported by CatBkt, without going through the TCP/IP protocol.